120
6.2 Access Point Association 6.2.1 Configure Wireless General Setting
The administrator can change the data transmission, channel and output power settings for the system. Please click on
Wireless -> General Setup and follow the below setting.
ESSID : Assign Service Set ID for the wireless system.
Band Mode : Select an appropriate wireless band; bands available are 801.11b, 802.11g and 802.11b+802.11g.
Transmit Rate Control : Select the desired rate from the drop-down list; the options are auto or ranging from 1 to
54Mbps for 802.11g and 802.11b/g modes, or 1 to 11Mbps for 802.11b mode.
Country : Select the desired Country code from the drop-down list; the options are US, ETSI or Japan.
Channel : The channel range will be changed by selecting different country code. The channel range from 1 to 11 for US
country code, or 1 to 13 for ETSI country code, or 1 to 14 for JP country code.
Tx Power : You can adjust the output power of the system to get the appropriate coverage for your wireless network.
Select the LEVEL 1 to LEVEL 9 you needed for your environment. If you are not sure of which setting to choose, then
keep the default setting, LEVEL 9.
Security Type : Select the desired security type from the drop-down list; the options are Disabled WEP, WPA-PSK and
WPA2-PSK.
Î Disable : Data are unencrypted during transmission when this option is selected.
Î WEP : Wired Equivalent Privacy(WEP) is a data encryption mechanism based on a 64-bit, 128-bit or 152-bit shared
key. The WEP key configured here must be exactly the same as the key on the access point that this system is
associated with.