AIRSTREAM LAND YACHT GAS
TIRE CHANGING (cont)
When removing a steel wheel rim to change a tire, loosen all wheel nuts approximately flush with
end of stud, then tap clamp ring to loosen rim. Do not remove nuts until clamp rings are free or
clamp ring may fly off of stud. When installing rim be sure pins on clamp ring face outboard.
Then tighten attaching nuts alternately and evenly to avoid excessive wheel run-out. See torque
values and sequence diagram. See tire inflation warning on page C-13.
LUG NUT TIGHTENING
Warning: WHEN A UNIT IS NEW, OR WHEN EVER A WHEEL, WHEEL
BOLT, OR WHEEL NUT IS REPLACED THE WHEEL NUT TORQUE MUST BE
CHECKED AT 100, 1,000 AND 6,000 MILES, AND EVERY 6,000-MILES
THEREAFTER.
TIGHTENING SEQUENCE
JACK PLACEMENT
Place the jack under the control arm to change front tires. Place the jack under the dual wheeled
axle close to the tires being changed for rear tires on dual-wheeled axles.