Aiwa AV-D35 Troubleshooting Guide, General, Tuner Section, Dolby Pro Logic, outputs, To reset

outputs

Muting

General

Power requirements Power consumption Dimensions

(W XHXD) Weight

AUDIO OUT (REC OUT): 200 mV (1 kohm)

VIDEO OUT (MONITOR): 1 Vp-p (75 ohms)

SUPER WOOFER: 1.2V

FRONT SPEAKERS IMP: 8L2

(front speakers A and B): accepts speakers of 8 ohms or more.

SURROUND SPEAKERS IMP: 8Q

(surround speakers): accepts speakers of 8 ohms or more CENTER SPEAKER IMP: 8Q: accepts a speaker of 8 ohms or more. PHONES (stereo jack): accepts headphones of 32 ohms or more

-20 dB

120 V AC, 60 Hz

125W

430 x 155 x 351 mm

(17 x 6’/8 x 137/8 in.)

10 kg (22 lb 1 OZ.)

TROUBLESHOOTING GUIDE

If the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound.

●Is the AC cord connected properly?

●Is there an incorrect connection? (+ page 3)

●There may be a short circuit in the speaker terminals.

+Disconnect the AC cord, then correct the speaker connections.

●Was an incorrect function button pressed?

●Was the TAPE MONITOR button pressed?

c Are the FRONT SPEAKERS A and B buttons set correctly? (+ page 6)

Sound is emitted from one speaker oniy.

●is the BALANCE set appropriateiy?

●is the other speaker disconnected?

Sound is heard at a very iow volume.

●Has the MUTi NG button been pressed?

An erroneous display or a malfunction occurs.

Specifications and external appearance are subject to change without notice.

DOLBY PRO LOGIC

Manufactured under license from Dolby Laboratories Licensing Corporation.

“DOLBY” the double-D symbol ❑O and “PRO LOGIC are trademarks of Dolby Laboratories Licensing Corporation.

+Reset the unit as stated below.

TUNER SECTION

There is constant, wave-like static.

●Is the antenna connected properly? (+ page 5)

●Is the FM signai weak?

+ Connect an outdoor antenna.

The reception contains noise interference or the sound is distorted.

●is the system picking up externai noise or multipath distortion?

+Change the orientation of the antenna.

+Move the unit away from other electrical appliances.

To reset

If an unusual condition in the dispiay window or malfunction occurs, reset the unit as foiiows.

1Press the POWER button to turn off the power.

2Press the POWER button whiie pressing the ENTER button.

Everything stored in memory after purchase is canceied.

if the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord and carry out step 2.

19 ENGLISH