PREPARATIONS
En
Remote Control
Insert two R6 (size AA) batteries
• When the reach of the remote control signal is less than 5 meters (16 feet), replace the batteries.
•Remove the batteries to prevent possible electrolyte leakage if the unit is not going to be used for a long period.
•The remote control may not operate correctly when:
-The unit is exposed to intense light, such as direct sunlight.
-Objects block the remote control signal to the unit.
Connections
The rated voltage of the unit, shown on the rear panel, is 120 V AC. Check that it matches your local voltage.
1Connect the speakers.
Connect the right speaker to the R terminals, and the left speaker to the L terminals on the rear panel. Connect the speaker cords with stripes to the + terminals.
Speakers
•Use only the supplied speakers.
•Do not leave objects generating magnetism or objects affected by magnetism near the speakers.
•Do not
Antennas
Keep antennas away from metallic objects, electrical equipment and cords.
•FM antenna: Extend it horizontally in a
end to the wall. For better reception, connect an optionally available outdoor antenna to the FM 75Ω terminals.
•AM antenna: Position and rotate it to find the best reception. Do not unwind the AM antenna wire.
To use the buttons on the remote control
Buttons on the remote control and the main unit with identical indications have the same functions (except for tape operation).
To turn the power on and off
Press POWER. When one of the deck operation buttons is pressed, this button will not turn the power off.
To use the FUNCTION button
Each time FUNCTION is pressed while the power is on, the function is selected cyclically.
CD TUNER AUX *TAPE
* applicable when one of the deck operation buttons is pressed
2Connect the supplied antennas.
The FM antenna to the FM 75 Ω terminals, and the AM antenna to the AM LOOP terminals.
3Connect the AC cord to an AC outlet. The STANDBY indicator lights up.
AUX jacks (rear)
Analog sound signals can be input through these jacks. Use a cable with RCA phone plugs (not supplied) to connect audio equipment (turntable with a
To listen to the connected equipment
1 Press AUX.
2 Play the connected equipment.
4
4 | 11/21/00, 10:26 AM |