Aiwa XR-EM20 manual Adjustments Before Operation, Power, Setting the clock

ADJUSTMENTS BEFORE OPERATION

TAPE,
TUNER/AUX/BAND,
CD	CLOCK	DISPLAY
POWER		CD,
6STANDBY/ON	TONE	TUNER/BAND,
		TAPE,AUX,s
s	DISPLAY
		f,g
	SET
	f,g SHIFT

To display the time while the power is on
Hold down SHIFT and press CLOCK on the remote control.
The time will be displayed for 6 seconds.
To switch to the 24-hour standard
Display the time and press swithin 6 seconds.
With each press, the clock alternates between 12- and 24-
hour standard time.	En
Tip:
In the 12-hour standard, "AM12:00" indicates midnight and
"PM12:00" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Reset the clock.

Power

Turning the unit on

Press POWER 6STANDBY/ON (POWER on the remote control).

Alternatively, press TAPE, TUNER/AUX/BAND (TUNER/BAND or AUX on the remote control) or CD. Playback will start automatically if a disc or tape is loaded.

Turning the unit off

Press POWER 6STANDBY/ON again.

The unit goes into standby.

To change the display window brightness (Dimmer) Hold down DISPLAY (hold down SHIFT and press DISPLAY on the remote control) for about 4 seconds while the power is on.

Repeat the above to restore the brightness.

Setting the clock

1Hold down SHIFT and press CLOCK on the remote control.

When the unit is turned off, you can also press SET.

2Within 6 seconds, press for gto set the time.

Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units.

3Press SET.

The time display stops flashing and the clock starts from 00 seconds.

When setting the clock on the unit in stop mode, hold down sand press gin step 1. After setting the time in step 2, press TONE in step 3.

7