•CC (Continuous Controller): The Interval Button will send a MIDI Continuous Controller (CC) message. If you select this, press the Trans Button to set additional message parameters:
oCn (Controller Number): This is the CC number that will be sent when you press the Interval Button. Use the Hold Button or Interval Button to set the CC number (01–127; values over 99 will be shown as the last two digits with a dot between them). Match this number to the CC number of the parameter you want to control.
odU (Data-Up):The value that will be sent with the CC message when you release the Interval Button. Use the Hold Button or Interval Button to set the value (00–127; values over 99 will be shown as the last two digits with a dot between them).
odP (Data-Press):The value that will be sent with the CC message when you press the Interval Button. Use the Hold Button or Interval Button to set the value (00–127; values over 99 will be shown as the last two digits with a dot between them).
oLA (Latching): This determines if the Interval Button acts as a latching control or momentary control. If you select this, press and hold the Trans Button to set additional message parameters:
OF (Off): When you press and hold the Interval Button, the Data-Press value will be sent. When you release the Interval Button, the Data-Up value will be sent.
on (On): When you press the Interval Button, the Data-Press value will be sent. When you press the Interval Button again, the Data-Up value will be sent.
4.To return to Performance Mode, press the Setup Button until the display is blank.
30
