HOW TO INITIALIZE THE TV/DVD/VCR
To put the program back at the
< DVD Section >
1.Turn the power on and press [SELECT] button on the remote control unit to put the TV/DVD/VCR into DVD mode.
2.Press [1], [2], [3], [4], and [DISPLAY] buttons on the remote control unit in that order.
Fig. a appears on the screen.
"*******" differ depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : CLEAR EXIT: SELECT
Fig. a
3.Press [CLEAR] button on the remote control unit. Fig. b appears on the screen.
"*******" differ depending on the models.
MODEL : *******
Version : *.**
Region : *
< TV/VCR Section >
1.Use the service remote control unit.
2.Turn the power on. (Use main power on the TV unit.)
3.Press [DISC MENU] button on the service remote control unit to enter the Service mode. (Refer to “How to enter the Service mode” on page
4.Press [VOL p] button on the service remote control unit twice, and confirm that OSD indication is “7F = FF.” If needed, set it to become “7F = FF” by pressing [CH. o / p] buttons on the service remote control unit.
5.Confirm that OSD indication on the four corners on TV screen changes from on and off light indication to red by pressing a [DISPLAY] button. (It is necessary for one or two seconds.)
6.Turn the power off by pressing main power button on the TV unit, and unplug the AC cord from the AC outlet.
EEPROM CLEAR : OK
EEPROM CLEAR : CLEAR EXIT: SELECT
Fig. b
When “OK” appears on the screen, the factory default will be set.
4.To exit this mode, press [CH. o / p] or [SELECT] button to go to TV mode, or press
T1202NT |
