Akai LCT3226 manual Antenna lead-in wire Antenna discharge unit NEC Section Ground clamp

Unplug the connector

IMPORTANT SAFEGUARDS

The power cable should be kept away from heat sources:

The heat produced by any heat source may melt the covering of the power cable.

Hold the power connector when removing the power cable:

Pulling the power cable itself may damage the wires inside the cable and cause fire or electric shock.

Do not touch the connector with wet hands:

To avoid risk of electric shock.

ATTENTION

Insert batteries in accordance with instructions:   Insert the batteries with correct polarities (positive and negative ). Incorrect polarities may cause breakage and leakage of the batteries, hurt operators and contaminate the remote controller.

Do not block or cover the vents:

Blocking the vents may cause overheating and fire. Do not install the product in a place with little or no ventilation. Never cover the vents with towels, blankets or dusters.

Unplug the connector:
Unplug the power connector when the product will not be used
for a long time.	Unplug the connector

Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges.(see Section 810 of the National Electric Code.)

Antenna lead-in wire

Antenna discharge unit (NEC Section 810-20)

Ground clamp

Electric service equipment

Ground clamp

Grounding conductors

(NEC Section 810-21)

Power service grounding

electrode system (NEC Art 250 Part H)

Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits. Never attempt to install any of the following during lightning activity: a). an antenna system; or b).cables, wires, or any home theater component connected to an antenna or phone system.

4