AKG Acoustics DMS700 specifications Display, Main Window, Channel Information Window

DMS

6 Display 700

Main Window

The general window shows all necessary parameters for operation. In addition to a freely-selectable name, the current frequency, the current group and channel, you can check the audio level, the ac- tive antenna, and the remaining use time of the transmitter battery. In case of a critical fault condi- tion (audio mute, low battery, audio clip) you will see a warning message.

Channel Information

Window

The Channel Information window provides a quick overview of the tuning parameters (group/chan- nel, frequency, name, country, bodypack audio input gain, attenuation pad, transmission power,en- cryption, and mute lock). All these parameters can be set and synchronized. The GROUNDLIFT and WORDCLOCK fields inidcate the related current status.

•To call up the channel information window, simply push the CH1 or CH2 button from the gen- eral window.

The battery symbols on the transmitter (C) and receiver (C) let you check the transmitter’s remain- ing battery capacity at a glance. Each segment equals approximately 1 hour of remaining battery life. If no battery voltage is detected or the information is invalid, no information is shown on the display. Approximately 1 hour before the battery will be dead the “LOW BATT” warning appears and the LED ring turns red.

The audio meter (E) indicates the audio output level of the receiver.

•To match the receiver’s output level to the connected mixer, you can adjust the level using the GAIN parameter in the AUDIO menu.

The output level is not properly adjusted if the audio meter goes off-scale or the input on the con- nected device is overloaded.

The audio output is muted. The status LED ring (11) is lit red. Since power and the RF section remain ON, no unwanted noise will become audible from the sound system when you mute the audio signal.

Battery Status

Indication

Audio Meter (E)

MUTE Indication (F)

11