ASSEMBLY
ASSEMBLY
DRIVELINE ATTACHMENT (Figure Asm-R-0129)
Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a shield.
1.Attach the slip clutch end of the driveline to the gearbox input shaft securely. Make certain that the slip clutch is fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the proper torque. Refer to Torque Chart in Maintenance Section.
SLIPCLUTCH SHIELD ASSEMBLY (Figure Asm-R-0130)
Insert bracket (3) into shield (1). Note: Short end of bracket (3) must be installed between rod and shield.
Remove top two bolts in front cover plate in gearbox. Attach shield assembly using 2 longer bolts (5) and washers (6) supplied. Spacers (4) must be installed between gearbox and shield bracket. Install bolts with lockwashers and tighten.
Install wing nut (2) to retain shield.
A84B 03/07 | Assembly Section |
© 2007 Alamo Group Inc.
