ASSEMBLY
DUAL TAIL WHEEL ASSEMBLY - LIFT TYPE - Figure AsmP-R-0022.
Attach the tailwheel beam (1) to the lug toward the outer edge of the deck just to the rear of the cross reinforcement using bolt (2 - not shown) & nut (3).
Attach the brackets (5 & 6) to the deck using bolts (7), washers (8), and nuts (9). Note: Formed leg with adjustment holes point to rear on part (5) and to front on part (6)
Install bolts (10) & nuts (11 - not shown) on top and bottom of tailwheel beam. Insert through pair of holes which will give approximate desired cutting height. Tighten all bolts..
A84B 03/07 | Assembly Section |
© 2007 Alamo Group Inc.
