21 TAPE
The TAPE button is used to access the tape interface features of the
Pressing the RECORD button initiates the save to tape. Both buttons can now be released, since this operation may take over two minutes, during which the display will read:
The display shows the current part or song being output. This display will advance until all data is output. Pressing the STOP/CONTINUE button will abort the operation. Before pressing RECORD, the page up and page down buttons can be used to access the other five tape pages. They are as follows:
In all five of these pages, pressing RECORD initiates the operation. The verify function is used to ensure that the data just recorded to tape is good. LOAD ALL PARTS & SONGS FROM TAPE loads the entire sequence memory with the data on tape. LOAD ONE PART FROM TAPE and LOAD ONE SONG FROM TAPE allow a single part or song to be loaded from a tape. The keypad can be used to select the desired number. For operations involving output to tape, after pressing RECORD the display will change to the following:
When the initial tone on the tape is detected, the display shows (depending on the page shown when RECORD was pressed):
- Page 31 -