Installation

Note: Ensure cables are routed safely and away from potential hazards. Use wire ties, included with the kit, to secure cabling.

Provide some slack for repositioning of the canister/filter/pump assembly after electrical connections are made.

d.One the 35- and 50-pound models, route the 2-conductor and 4-conductor cable through the two PG 13.5 strain reliefs installed in step b. See Figure 23. On the 85-pound model, route both the 2-conductor cable and the 4-conductor cable through the PG 21 strain relief as shown in Figure 24.

Note: Ensure strain reliefs are tightened securely around the cable.

e.Connect red wire in the 2-conductor cable from the canister/filter/pump assembly to terminal A2 of the pump contactor. See Figure 23.

f.Extend 2-conductor cable #223, which is capped in the rear control module. Connect red wire of #223 to the black wire of the 2-conductor cable from the canister/filter/pump assembly.

g.Connect the black wire of the #223 cable to terminal A1 of the pump contactor.

h.Connect L1, L2, and L3 from the circuit breaker to the input side of the mains contactor, using the 18GA gray wire, included in the kit.

40

i.Connect the 4-conductor cable wires to the pump contactor terminals as follows: wire No. 1 to terminal T1, wire No. 2 to T2, and wire No. 3 to T3. Wire No. 4 (green-yellow) must be connected to the chassis ground.

Note: If pump motor rotation is incorrect during the control function test, swap any two wires at terminals T1, T2, or T3 of pump contactor. See Figure 26 for correct motor rotation direction.

7.Verifying electrical connections:

a.Secure any loose or dangling wires, using the wire ties.

b.Verify that all connections are secure and routed properly.

8.Reassembling machine panels:

a.Reassemble rear panel and right front panel.

b.Reinstall rear control module cover.

9.Install water recirculation piping:

a.Remove the cap on the recirculation inlet on top of the shell. See Figure 20.

b.Attach the 1 1/2-inch black hose connector (no clamp grooves), included in the kit, between the shell recirculation inlet and the adapter plate.

c.Attach upper recirculation pipe to the hose connector at the recirculation adapter plate on the rear of the washer- extractor. See Figure 26.

F232058