Auxiliary Heat

Heat is a dedicated output of the V-computer, which controls an optional heat source. If “noHt” is selected, the heat output will never energize during a cycle (except briefly in the test cycle to ensure that the output functions properly), regardless of programmed temperature settings. If “HEAt” is selected, the output will energize during a cycle if the three following conditions are true:

●A nonzero heat temperature is programmed.

●The computer senses that the present temperature is below the programmed target temperature.

●There is at least a low water level in the machine.

NOTE: Do not enable the auxiliary heat setup option and disable the temperature-controlled fill option on machines not equipped with auxiliary heat. The machine will pause for 40 minutes during any cycle segment where the fill water temperature does not equal or exceed the programmed value of the heat step.

Supply 5 or Auxiliary Fill

If “SUP5” is selected, the output labeled AF on the solid state output board can be used to control a fifth supply signal. This setup option must be selected to program an “SUP5” or an “SUP6” (supply 1 and supply 5 combined) in a cycle step.

If “AFIL” is selected, the output labeled AF can be used to control an auxiliary fill valve. Auxiliary fills can be programmed to low, medium, or high water level. This setup option must be selected to program an “AFIL” in a cycle step.

Temperature-Controlled Fill

If “tFIL” is selected, a temperature-controlled fill can be programmed for any segment. This setup option must be selected to program a “tFIL” in a cycle step. If “ntFL” is selected, this feature is disabled.

Automatic Cool-Down

If “CooL” is selected, the automatic cool-down feature is enabled. If the wash solution is 140°F (60°C) or higher when a cycle step calls for a drain, the washing action will continue and the cold water valve will begin flushing cold water into the wash solution. Once the wash solution temperature drops below 140°F (60°C), the drains open and the cycle continues as programmed. If “noCL” is selected, this feature is disabled.

Programming

Cycle Count

To display the current cycle count, press the Start key while the display is showing the temperature in the sump. The display will show a two-digit number indicating how many cycles have been run to completion (cycles which were stopped in progress are not counted). Press the Start key to return to Program Mode without resetting the count. Press the Up or Down key to reset the count to zero and return to Program Mode.

Cycle Programming

To edit an existing cycle or create a new cycle, press the Up key while the display is showing the temperature in the sump. The display will show “CY01.” Press the Up or Down key until the desired cycle number is displayed. Press the Start key to begin editing the selected cycle.

F232182

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

15