Alliance Laundry Systems F232182R1 NOTE: Every intermediate spin is followed by a, NOTE: The drain step in the final segment (Fill 9) cannot be skipped

Programming

6.Press the Start key.

7.Use the Up or Down key to select the desired supply option. Refer to Table 6.

	Supply Options

Display		Supply

SUP0		No Supply

SUP1		Supply 1

SUP2		Supply 2

SUP3		Supply 3

SUP4		Supply 4

SUP5		Supply 5*

SUP6		Supply 1 and 5*

SUP7		Supply 3 and 4

*This is available only if the “SUP5”/“AFIL” setup option is set to “SUP5.”

Table 6

8.Press the Start key.

9.If the temperature-controlled fill or the auxiliary heat setup option is enabled, use the Up or Down key to select the desired segment temperature. To disable auxiliary heat and temperature-controlled fill for this segment, set this value to zero. Press the Start key.

NOTE: If the temperature-controlled fill setup option is enabled and an auxiliary fill has been selected for the segment, the segment temperature should be set to zero. Otherwise, the auxiliary fill valve will enable for only three seconds at the beginning of the fill before the computer begins using the hot and cold fill valves to reach the programmed temperature.

10.Use the Up or Down key to select the desired drain option. If “drAI” is selected, the machine will drain after the segment time has elapsed. If “nodr” is selected, the machine will not drain and the spin step will be skipped entirely. Press the Start key.

NOTE: The drain step in the final segment (Fill 9) cannot be skipped.

11.For final “FIL9” spin only, use the Up or Down key to select the desired spin speed. Refer to Table 7.

	Spin Options

Display		Spin Speed

SPn1		Low Spin

SPn2		Medium Spin

SPn3		High Spin

	Table 7

12.Press the Start key.

13.Use the Up or Down key to select the desired spin time. Set this value to zero to skip the spin step. Press the Start key. The display will now show the identifier for the next program segment (or return to the temperature display if the edited segment is the Fill 9 segment).

NOTE: Every intermediate spin is followed by a

25 second coast-down period, which occurs during the fill step for the following segment.

14.Press the Stop key at any time to complete the cycle programming procedure.

F232182