Step 2:

Connect Water Inlet Hoses

NOTE: Refer to section on Water Supply Requirements before connecting water inlet hoses.

Remove the four plain rubber washers from accessories bag, and install them according to the illustration.

Turn on the water supply faucets and flush the lines for approximately two minutes to remove any foreign materials that could clog the screens in the water mixing valve.

NOTE: When installing in newly constructed or renovated building, it is very important to flush the lines since build-up may have occurred during construction.

IMPORTANT: Thread hose couplings onto valve connections finger-tight, then approximately 1/4 turn with pliers. DO NOT cross thread or overtighten couplings.

Turn water on and check for leaks. If leaks are found, retighten the hose couplings. Continue tightening and rechecking until no leaks are found.

RUBBER WASHER

(Plain)

 

RUBBER WASHER

 

(Plain)

 

INLET

 

HOSE

INSTALL THIS

 

END OF HOSE

INSTALL THIS END OF HOSE

TO WATER

TO VALVE CONNECTIONS

SUPPLY FAUCET

AT REAR OF WASHER

 

 

H091IE1A

 

COLD WATER

 

CONNECTION

HOT WATER

CONNECTION

WATER SUPPLY

FAUCETS

WATER INLET

HOSES

H100IE1A

8

685945