Step 4:
Remove the Shock Sleeves and Shipping Brace
Remove front access panel by removing the two screws.
Remove bolts and washers from shipping brace with 9/16" wrench and remove brace. Remove shock sleeves by pulling on the yellow rope. Remove label from front side of front access panel and place on backside of front access panel.
NOTE: The shipping brace, bolts, washers and shock sleeves should be saved and MUST be reinstalled whenever the washer is moved more than four feet. Do not lift or transport washer from front or without shipping materials installed.
Store the shipping materials in the bag provided in the Accessories Bag. Save materials for use whenever the washer is moved.
Reinstall front access panel.
SHOCK SLEEVES
HOOKED | MOTOR |
END OF | |
SHIPPING | MOUNT |
BRACE |
|
BOLTS
WASHERSH027IE1B
NOTE: The shipping materials MUST be reinstalled whenever the washer is moved. Refer to Moving Washer to a New Location section for instructions.
Step 5:
Position and Level the Washer
Place washer in position on a clean, firm and reasonably level floor. Installing the washer on any type of carpeting is not recommended.
Loosen 9/16" locknuts and adjust the leveling legs until the washer does not rock.
NOTE: Level must rest on raised portion of top panel. See illustration.
Tighten the locknuts securely against the washer base using the 9/16" wrench. If the locknuts are
not tight, washer will move out of position during operation.
CAUTION
DO NOT slide washer across floor if the leveling legs have been extended, as legs and base could become damaged.
W248
CAUTION
Use of the dispenser drawer or washer door as a handle in the transportation of the washer may cause damage to the dispenser or door.
W185
Remove rubber feet from accessories bag and place on all four leveling legs.
LEVEL
WASHER
BASE
LEVELING
LEG
RUBBER | H221IE1A |
CUP | LOCKNUT |
|
10 | 685945 |