Washer Slide Extension . . .
(Coin Slide Models Only)
WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the washer before servicing.
•Never start the washer with any guards/ panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the washer is properly grounded.
W003
Remove slide extension, shoulder screw, plastic boot, actuator, actuator support, screws and lockwashers from the accessories bag. Install slide extension as follows:
1.Unlock and open service door. Remove locking rod holding coin slide to front of security cabinet.
NOTE: Refer to following illustration for Steps 2 through 4.
H067I
2.Assemble plastic boot (No. 36165) onto actuator support (No. 685592).
3.Assemble actuator (No. 36164) to actuator support (No. 685592) using shoulder screw (No. 36166).
4.Place actuator and support assembly onto slide extension, and install screw and lockwasher (No. 03950).
5.Install assembed slide extension through coin slide opening of security cabinet by reaching through service door opening.
6.Assemble slide extension (No. 685593) to top side of coin slide using two screws and lockwashers (No. 03950), and tighten firmly. See illustration below.
H068I
7.Reinstall assembled coin slide in security cabinet. Close and lock service door.
After slide extension has been installed, check washer operation as follows:
1. Connect electrical power to washer.
NOTE: To determine if slide functions properly, allow washer to complete its cycle, and for timer to stop, before starting evaluation process.
2.Place required number of coins in slide. Push slide in slowly and listen for coins to drop into coin drawer.
3.Push slide in a little farther and observe through service door opening that actuator drops beyond timer clutch. Continue pushing slide all the way in and pull back. Confirm that the actuator will rotate timer clutch and wash cycle starts.
NOTE: Washer will not start until
6 | 685945 |