Step 4: Connect Drain Hose to Drain Receptacle

Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp.

Find the instructions, on the following pages, that are appropriate for your type of drain receptacle (standpipe, high standpipe, low standpipe, sink, wall, or laundry tub). Follow these instructions to properly install the drain hose.

IMPORTANT: Drain receptacle must be capable of handling a minimum of 32 cm (1-1/4 inch) outside diameter drain hose.

1

2

W324I

1Retainer Clamp

2Standpipe Adapter

Figure 5

Installation

Standpipe Installation

Place the adapter into the standpipe.

Remove the beaded tie-down strap from accessories bag and place around standpipe and drain hose, approximately 30 cm (12 inches) down from the top of pipe and tighten strap to hold hose to standpipe. This will prevent the drain hose from dislodging from drain receptacle during use.

IMPORTANT: To prevent siphoning, do not place any ribbed portion of the drain hose into the standpipe.

1

2

3

 

 

 

30 cm

(12 in.)

91,44 cm

(36 in.)

RECOMMENDED

HEIGHT

4

TLW1961N

5

TLW1961N

1Drain Hose Sleeve

2Ribbed Portion of Drain Hose

3Standpipe Adapter

4Tie-Down Strap

5Standpipe – 5,08 cm (2 in.) or 4 cm (1-1/2 in.) Diameter

Figure 6

38910

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9