Alliance Laundry Systems LWK23A-3050, LWK24A-3050, LWK73A-3050, LWK74A-3050 Step 6: Plug In the Washer, Step 8: Check Lid Switch, Step 7: Add Water to the Washer, Step 9: Check Installation, Installer Checklist, Electrical Requirements

Installation

Step 6: Plug In the Washer

Refer to section on Electrical Requirements, and plug the washer in.

Step 8: Check Lid Switch

Washer should stop spinning when lid is opened.

W504SE3B

Figure 13

Step 7: Add Water to the Washer

To prevent damage to pump, do not run washer before adding at least one quart water to the tub. If the washer is run before any water is added, the pump seal may overheat causing the pump to leak. Once installed, the water retained in the drain system from the previous cycle will provide sufficient cooling to prevent pump seal damage.

NOTE: The agitator should not be removed except for service. The washtub is designed to be self- cleaning.

W391I

Figure 14

W376IE0C

Figure 15

Step 9: Check Installation

Refer to Installer Checklist on the back cover of this manual and make sure that washer is installed correctly.

38910