Installation

Laundry Tub Installation

For this type of installation, the drain hose MUST be secured to the stationary tub to prevent hose from dislodging during use. Use the beaded tie-down strap (supplied in accessories bag) to secure hose.

We recommend leaving the standpipe adapter on the drain hose for this type installation.

1

TLW1964N

1Tie-Down Strap (Tape if necessary)

Figure 11

Step 5: Position and Level the Washer

Position washer so it has sufficient clearance for installation and servicing.

Place rubber feet on all four leveling legs.

Place washer in position on a clean, dry, and reasonably firm floor. Installing the washer on any type of carpeting is not recommended.

Loosen 7/8 inch locknuts and adjust the two front leveling legs. Once adjusted, tilt the unit forward on front legs and lower back down into position to set the rear self-leveling legs.

Washer must not rock. After washer is at desired height, tighten locknuts securely against bottom of washer base. If these locknuts are not tight, washer will not remain stationary during operation.

Improper installation or flexing of a weak floor will cause excessive vibration.

Do not slide washer across floor once the leveling legs have been extended, as legs and base could become damaged.

Recheck to make sure washer does not rock.

1

2

3

4

5

W179I

W179I

1Level

2Washer Base

3Locknut

4Leveling Leg

5Rubber Cup

Figure 12

12

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

38910