Clearing an Alarm:
1.Note alarm code flashing on program display in order to look it up and correct problem.
2.Press ENTER button and display will be cleared. PS40 control will continue running normally.
An alarm code indicates a potential machine problem or condition that should be examined.
Clearing a Fault:
1.Note fault code flashing on program display in order to look it up and explain problem to a qualified technician.
2.Wait until machine has stopped and door is unlocked.
3.Open door.
4.Press
5.Call a qualified service technician.
6.When power is restored fault will be cleared and PS40 control will attempt to run again.
WARNING
The PS40’s fault codes indicate potentially hazardous operating conditions. If a Fault occurs the machine should be shut off and locked out until a service technician can repair the machine. All fault codes are indicated by a flashing “Fn” display. Where F indicates a fault condition, and n indicates the particular fault number.
W687
Operation
Tips:
•Always try to load machine as fully as possible. Small loads are generally harder on any front loading washer and cannot be processed as efficiently. They use more water per pound and more electrical energy.
•Use appropriate low sudsing detergents and chemicals.
•If a power failure interrupts machine during a program, program can be resumed where it was interrupted when power is restored by pressing START button on control.
•To add goods after a program has been started, press STOP button. After machine has drained and is safe, it will unlock door. Open door and add additional goods to be processed. Close door and press START button to restart program where it left off.
•If wrong program number is accidentally entered, control will allow you to reenter it and change program being run for up to 3 minutes.
F8112201 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 13 |