Safety Information
DANGER
Do not place volatile or flammable fluids in any machine. Do not clean the machine with volatile or flammable fluids such as acetone, lacquer thinners, enamel reducers, carbon tetrachloride, gasoline, benzene, naptha, etc. Doing so could result in serious personal injury and/or damage to the machine.
SW002
•Water Damage. Do not spray machine with water. Short circuiting and serious damage may result. Repair immediately all seepage due to worn or damaged gaskets, etc.
Machine Location•Foundation. The concrete floor must be of sufficient strength and thickness to handle floor loads generated by high extract speeds of machine.
•Service/Maintenance Space. Provide sufficient space to allow comfortable performance of service procedures and routine preventive maintenance.
Consult installation instructions for specific details.
CAUTION
Replace all panels that are removed to perform service and maintenance procedures. Do not operate the machine with missing guards or with broken or missing parts. Do not bypass any safety devices.
SW019
•Water Pressure. Best performance will be realized if water is provided at a pressure of 30 – 85 psi (2 – 5.7 bar). Although machine will function properly at lower pressure, increased fill times will occur. Water pressure higher than 100 psi (6.7 bar) may result in damage to machine plumbing. Component failure(s) and personal injury could result.
•Steam Heat (Optional) Pressure. Best performance will be realized if steam is provided at a pressure of 30 – 80 psi (2 – 5.4 bar). Steam pressure higher than 125 psi (8.5 bar) may result in damage to steam components and may cause personal injury.
For machines equipped with optional steam heat, install piping in accordance with approved commercial steam practices. Failure to install supplied steam filter may void warranty.
•Drainage System. Provide drain lines or troughs large enough to accommodate total number of gallons that could be released if all machines on site drained at same time from highest attainable level. If troughs are used, they should be covered to support light foot traffic.
•Power. For personal safety and for proper operation, machine must be grounded in accordance with state and local codes. Ground connection must be to a proven earth ground, not to conduit or water pipes. Do not use fuses in place of circuit breaker. An
WARNING
Ensure that a ground wire from a proven earth ground is connected to the ground lug near the input power block on this machine. Without proper grounding, personal injury from electric shock could occur and machine malfunctions may be evident.
SW008
Always disconnect power and water supplies before a service technician performs any service procedure. Where applicable, steam and/or compressed air supplies should also be disconnected before service is performed.
6 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F8112201 |