Alliance Laundry Systems PHM1397C 19

3.Verify V-belts are properly aligned by checking pulley alignment. Place a straight edge across both pulley faces. The straight edge should make contact with pulleys in two places. Refer to Figure 4.

	1
2	3	5
		4

P045I

1Drive Motor

2Drive Pulley

3Belt

4Straight Edge

5Drive Pulley

Figure 4

4.Remove back panel and check all hoses for leaks, cracking and deterioration.

5.Open machine top cover and check supply dispenser hoses and hose connections for leaks.

6.Remove front service panel. Check all hoses and temperature probe for leaks, cracking and deterioration.

Maintenance

7.Clean inlet hose filter screens:

a.Turn water off and allow valve to cool, if necessary.

b.Unscrew inlet hose and remove filter screen.

c.Clean with soapy water and reinstall. Replace if worn or damaged.

8.Make sure that all hose clamps are tight and all hoses are secure

9.Tighten motor mounting bolt locknuts and bearing bolt locknuts, if necessary.

10.Verify that motor plate mounting bolt is tight but plate is free to pivot.

11.Use compressed air to clean dust and lint from motor.

12.Clean interior of washer-extractor, both basket and shell, by wiping with a water-soaked sponge or cloth.

13.Open rear electrical enclosure and clean out any dust or lint build up in box with a vacuum cleaner and a soft brush. Lint build-up can result in a fire hazard.

WARNING

Do not clean the cooling fans with compressed air! Doing this spins the fan too fast and will cause premature fan failures.

W695

14.Remove chemical supply components and check for residual chemicals. Clean as necessary and replace.

F8112201