Alliance Laundry Systems PHM1397C Monthly

Maintenance

Monthly

NOTE: Disconnect power to washer-extractor at its source before performing monthly maintenance procedures.

Keep the following lubricants on hand for periodic maintenance of machine.

	Main	Shell Alvania® 71125 Grease
	Bearings

	Motor	Motor bearings are sealed and do not
	Motor	require service.
		require service.

	Door	Silicon Spray Grease
	Latch	Silicon Spray Grease
	Latch

	Door	Silicon Spray Grease
	Handle	Silicon Spray Grease
	Handle

1.Each month or after 200 hours of operation, lubricate bearings using grease fittings located in upper rear panel. Pump grease gun slowly, using full strokes. Use the following schedule to determine number of strokes to use for machine.

	Number of strokes per
Machine	month or 200 hours of
Machine	operation
type	operation

	Front	Rear
	Front	Rear
	Bearing	Bearing

40M, 60M	2	1

40H, 60H, 80M, 100M	2	2

80H, 100H, 125H, 140M	3	2

140H, 175H	4	2

The grease must have the following characteristics:

•NLGI Grade 2

(Recommended: Shell Alvania® #71125)

•Lithium-based

•Water-insoluble

•Anti-rusting

•Anti-oxidizing

•Mechanically stable

The grease must have adequate base oil viscosity with one of the following ratings:

•ISO VG 150 (135 – 165 cSt at 40°C or 709 – 871 SUS at 100°F)

•ISO VG 220 (198 – 242 cSt at 40°C or 1047 – 1283 SUS at 100°F)

•An SAE 40 rating is also acceptable as long as cSt or SUS values are within specified ranges.

WARNING

Never mix grease types (Ex. Silicon, Petroleum, Lithium, Poly-Urea)! Never use any grease other than that specified at the grease fittings on the machine. Doing so may cause premature bearing failure and void any applicable warranties.

W694

If machine is fitted with SKF System 24® automatic lubricators, check that they are functioning by noting piston position each month. Set them to dispense their contents over 12 months for all machine models.

Always mark new lubricators with installation date.

2.Remove rear service panel and inspect drive belts for uneven wear, frayed edges or cracking. Push on belts and make sure motor can move about its pivot point (this ensures belts are automatically being tensioned correctly).

F8112201