Additional Security

Torx security screws are available (as optional equipment at extra cost) for securing both lower access panels to each dryer base. Order Part No. 62853.

A Torx bit, Part No. 282P4, is available (as optional equipment at extra cost) for installing the Torx security screws.

A Torx bit holder, Part No. 24161, is available (as optional equipment at extra cost) to be used with the Torx bit.

Slide Extension(Coin Slide Models Only)

Remove two slide extensions, four screws and lockwashers from the accesssories bag (located in lower cylinder) and install the extension on the top of the coin slide.

IMPORTANT: Slide extension must be attached to top side of the coin slides to make them long enough to activate the accumulator.

NOTE: This dryer unit, as shipped from the factory, does not include the coin slides, coin drawers, lock or keys. These coin slide kits (or parts) must be ordered, at extra cost, according to the purchaser’s requirements direct from the coin kit manufacturer of your choice.

Timer Cams

(Coin Slide Models Only)

The dryer timers are factory equipped with a

45 minute timing cam. If this drying time is not suitable to your installation, the following cams can be found in the accessories bag (located in lower cylinder).

ELECTRIC DRYERS

2-53242 Cams (30 Minutes)

2-53240 Cams (60 Minutes)

Installation

GAS DRYERS

2-53242 Cams (30 Minutes)

A 60 minute timing cam, Part No. 53240, is available for the gas dryers as optional equipment at extra cost.

To change the timing cam:

1.Align notch in cam with a tooth on ratchet wheel.

2.Squeeze the ends of the two timing cam prongs together.

3.Carefully lift timing cam off post.

NOTE: Adjust ratchet wheel and timing cam to “OFF” position prior to putting dryer into use. Refer to Figure 1 for proper position.

1

6

5

42

3

D775I

7

D775I

1Retaining Prongs

2Timing Cam

3Notch

4Levers

5Off Position

6Ratchet Wheel

7On Position

Figure 1

510975

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

11