Alliance Laundry Systems Stacked Clothes Dryer Installing the Dryer, Step 1: Position and Level the Dryer Unit, Step 2: Connect Dryer Unit Exhaust System

Installation

Installing the DryerStep 1: Position and Level the Dryer Unit

For further assistance, refer to section on Location Requirements.

Install dryer before washer. This allows room for attaching exhaust duct.

Install the four rubber cups found in the accessories bag.

Place the dryer in position, and adjust the legs until the dryer is level from side to side and front to back.

2

1

3

D690I

4

D690I

1Dryer Base

2Level

3Leveling Leg

4Rubber Cup

Figure 5

Step 2: Connect Dryer Unit Exhaust System

For further assistance, refer to sections on Location Requirements and Dryer Exhaust Requirements.

WARNING

A clothes dryer produces combustible lint. To reduce the risk of fire and combustion gas accumulation the dryer MUST be exhausted to the outdoors.

W116

●DO NOT use plastic or thin foil ducting.

●Locate dryer so exhaust duct is as short as possible.

●Be certain old ducts are cleaned before installing your new dryer.

●Use 4" (10.2 cm) diameter rigid or flexible metal duct.

●The male end of each section of duct must point away from the dryer.

●Use as few elbows as possible.

●Use duct tape or pop-rivets on all duct joints.

●Ductwork that runs through unheated areas must be insulated to help reduce condensation and lint build-up on pipe walls.

●Install backdraft dampers in multi-dryer installations.

●Failure to exhaust dryer properly will void warranty.

.

DO		DON’T
	D354I		D356I

Figure 6

NOTE: Venting materials are not supplied with the dryer (obtain locally).

14 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 510975