Alliance Laundry Systems W001C Step 3: Connect Fill Hoses, Water Supply Requirements

Installation

Step 3: Connect Fill Hoses

NOTE: Refer to section on Water Supply Requirements before connecting fill hoses.

The appliance is to be connected to the water mains using new hose-sets and old hose-sets should not be reused.

Turn on the water supply faucets and flush the lines for approximately two minutes to remove any foreign materials that could clog the screens in the water mixing valve.

NOTE: When installing in newly constructed or renovated building, it is very important to flush the lines since build-up may have occurred during construction.

Remove the two plain rubber washers and two filter screens from accessories bag, and install them according to Figure 4.

NOTE: Check filter screens for debris or damage annually. Clean or replace them if necessary.

IMPORTANT: Thread hose couplings onto valve connections finger-tight, then approximately 1/4 turn with pliers. DO NOT cross thread or overtighten couplings.

Turn water on and check for leaks. If leaks are found, retighten the hose couplings. Continue tightening and rechecking until no leaks are found.

	3
COLD
HOT
2	C
	H

TLW1988N

1Filter Screen (Screen must be facing outward)

2Fill Hose

3Rubber Washer (Plain)

4Cold Water Connection

5Hot Water Connection

6Install this end of hose to valve connections at rear of washer.

7Install this end of hose to water supply faucet. (Black colored coupling for metric)

8Faucet

Figure 4

IMPORTANT: Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters or material wear from the temperature and constant high pressure they are subjected to.

All hoses should be checked on a yearly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every 5 years.

38900