Step 4: Connect Drain Hose to Drain Receptacle

Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp.

Find the instructions, on the following pages, that are appropriate for your type of drain receptacle (standpipe, high standpipe, low standpipe, sink, wall, or laundry tub). Follow these instructions to properly install the drain hose.

IMPORTANT: Drain receptacle must be capable of handling a minimum of 3.2 cm (1-1/4 inch) outside diameter drain hose.

Installation

Standpipe Installation:

Place the hose into the standpipe.

Remove the beaded tie-down strap from accessories bag and place around standpipe and drain hose, approximately 30 cm (12 inches) down from the top of pipe and tighten strap to hold hose to standpipe. This will prevent the drain hose from dislodging from drain receptacle during use.

IMPORTANT: To prevent siphoning, do not place any ribbed portion of the drain hose into the standpipe.

1

2

1 2

5

30 cm (12 in.)

19.44 cm

(36 in.)

RECOMMENDED

HEIGHT

3

4

TLW1961N

TLW1961N

W324I

1Retainer Clamp

2Standpipe Adapter

Figure 5

1Ribbed Portion of Drain Hose

2Standpipe Adapter

3Tie-Down Strap

4Standpipe 5.08 cm (2 in.) or 4 cm (1-1/2 in.) Diameter

5Drain Hose Sleeve

Figure 6

38900

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9