Alliance Laundry Systems W001C Step 6: Connect the Washer to Electrical Power, Step 7: Add Water to the Washer, Step 8: Check Lid Switch, Step 9: Check Installation, Installer Checklist

Step 6: Connect the Washer to Electrical Power

Refer to section on Electrical Requirements and connect the washer to an electrical power source.

D254I

Figure 13

Step 7: Add Water to the Washer

To prevent damage to pump, do not run washer before adding at least one quart water to the tub. If the washer is run before any water is added, the pump seal may overheat causing the pump to leak. Once installed, the water retained in the drain system from the previous cycle will provide sufficient cooling to prevent pump seal damage.

NOTE: The agitator should not be removed except for service. The washtub is designed to be self- cleaning.

W391I

Figure 14

Installation

Step 8: Check Lid Switch

Washer should stop agitating and spinning when lid is opened.

W376IE0A

W376I

Figure 15

Step 9: Check Installation

Refer to Installer Checklist on the back cover of this manual and make sure that washer is installed correctly.

38900