Route Update Queue Length (CR00010196) | 75 |
Figure 4: Output of the show switch command when hardware learning delay is enabled
Switch Configuration
Switch Address | ............. | ||
Learning | ................... | ON | |
Ageing Timer | ON | ||
IP route: |
|
|
|
Learn | delay | ............. | 4 ms |
| queue | size | 0 |
| queue | limit | 1000000 |
| percent in use .... | 0 | |
| high water mark ... | 0 | |
| queue | maximum | 1500000 |
| queue | default | 1000000 |
Updating hardware(status) | 0 (Pending) | ||
.
.
.
Table 1: New parameters in the output of the show switch command
Parameter | Meaning |
|
|
Queue size | The number of entries currently in the hardware route update queue. |
|
|
Queue limit | The maximum number of entries that the queue can hold. |
|
|
Percent in use | The percentage of the queue limit that is currently used. |
|
|
High water mark | The highest number of messages that have been seen on the queue since the switch last started up. |
|
|
Queue maximum | The maximum value to which you can set the queue size. This depends on the amount of memory installed on the switch. |
|
|
Queue default | The default maximum number of entries in the queue. This depends on the amount of memory installed on the switch. |
|
|
Updating hardware (status) | The number of entries that the software has queued for writing into the hardware table, followed by the status. Status |
| is Pending if the hardware is not currently processing queued routes and Active if it is currently processing the routes. |
|
|
Version
