Allied Telesis AT-MC606 Wall-Mounting the Subscriber Unit, Cabling the Subscriber Unit

AT-MC606 VDSL Network Extender Installation Guide
35
5. Go to “Cabling the Subscriber Unit” on page 35 to connect the cables
and to “Powering On the Subscriber Unit” on page 37 for powering the
unit.
Wall-Mounting
the Subscriber
Unit
The AT-MC606 VDSL Network Extender may be wall mounted directly to
the wall with an AT-WLMT Wall Mount Bracket or by using an Allied
Telesis DINRAIL Bracket (both supplied separately) in conjunction with a
previously mounted DINRAIL.
1. Configure the right VDSL CONFIG switch (SCBR/PROV) to the SCBR
position as shown in Figure 8, ”Configuring AT-MC606 Ethernet
Extender for Subscriber Mode” on page 34.
2. Follow the installation instructions supplied with the wall mounting
bracket.
3. Go to “Cabling the Subscriber Unit” on page 35 to connect the cables
and to “Powering On the Subscriber Unit” on page 37 for powering the
unit.
Cabling the
Subscriber Unit
To cable the Subscriber unit to a computer, perform the following steps:
1. Connect the Ethernet cable from the AT-MC606 Ethernet port to the
Ethernet port on your computer, as shown in Figure 9.
Figure 9. Connecting AT-MC606 Ethernet Port to Computer
1937
ASYMFAST
SCBR 6dB
SYM
INTL
PROV9dB
VDSL CONFIG
10Base-T/
100Base-TX
LNK/ACT
100M
PWR
VDSL LINE
LINK
RATE
PROV
SCBR
AT-MC606
VDSL EXTENDED ETHERNET