Allied Telesis AT-MC606 External AC/DC Power Adapter

AT-MC606 VDSL Network Extender Installation Guide

External AC/DC Power Adapter

An external, energy efficient, AC/DC power adapter is included with the

AT-MC606 VDSL Network Extender for desktop or wall-mount operation.

The power adapter supplies 12V DC to the AT-MC606. Allied Telesis

supplies an approved safety compliant AC power adapter specifically

designed for each region where the AT-MC606 VDSL Network Extender is

sold. Each type of power adapter has an unregulated output of 12V DC at

1A.

The AT-MC606 VDSL Network Extender has a single DC power supply

socket on the back panel. The unit does not have a power switch. To turn

the unit ON or OFF, you must connect or disconnect the DC power cord.

Contents

Main Page Electrical Safety and Emissions Standards This product meets the following standards. U.S. Federal Communications Commission Industry Canada Page Contents Page List of Figures Page Page Page Preface Safety Symbols Used in this Document Page Contacting Allied Telesis Chapter 1 Overview Summary of Features Page AT-MC606 Port Descriptions VDSL Line Port 10Base-T/ 100Base-Tx Ethernet Port Type of Cabling Auto MDI/MDI-X Half- and Full-duplex Mode RJ-45 Port Pinouts Status LEDs 10Base-T/100Base-TX Ethernet Port Coaxial VDSL LINE Port VDSL Configuration DIP Switches VDSL Switch Definitions VDSL Configuration DIP Switch Descriptions SCBR/PROV VDSL Configuration Switch FAST/INTL VDSL Configuration Switch ASYM/SYM VDSL Configuration Switch 6 dB/9 dB VDSL Configuration Switch External AC/DC Power Adapter Applications for the AT-MC606 VDSL Network Extender Building Equipment Room POWER MCR12 Multiple Dwelling Unit (MDU) Topology IP Surveillance Topology AT-9424T ADSL AT-AR440 Internet 12 AT-MC606 Subscriber Units mounted in an AT-MCR12 Chassis Installation Reviewing Safety Precautions Selecting a Site for the AT-MC606 VDSL Network Extender Required Cabling Unpacking the AT-MC606 VDSL Network Extender Installing the AT-MC606 VDSL Network Extender Subscriber Unit Using the Subscriber Unit on a Desktop Wall-Mounting the Subscriber Unit Cabling the Subscriber Unit Figure 10. VDSL Line to Wall/Interior Coaxial Cable MCR12 Note The AT-MC606 coax connector has a built-in termination, so an external termination is not required. AT-MC606 Page Installing the AT-MC606 VDSL Network Extender Provider Unit Using the Provider Unit on a Desktop Wall-Mounting the Provider Unit Rack-Mounting the Provider Unit AT-MC606 VDSL EXTENDED ETHERNET AT-MC606 POWER Cabling the Provider Unit Powering On the Provider Unit Chapter 3 Troubleshooting LEDs Power LED LINK/ACT LED - 10Base-T/100BaseTX Ethernet Port LINK LED - Coaxial VDSL LINE Port Technical Specifications