Allied Telesis ATFS705EFCSC60 manual Verifying and Troubleshooting the Installation

Note

To prevent the DC power cable from being inadvertently pulled out of the switch, use the cable tie supplied with the unit to secure the DC power cable to the small cable hook located next to the DC connector.

6.Connect the twisted pair cables to the RJ45 connectors on the switch.

7.Remove the dust cover from the fiber optic port and connect the fiber optic cable to the port.

8.Set the 100FX DUPLEX switch to either HALF for half-duplex or FULL for full-duplex operation. The capabilities of the end node connected to the fiber optic port will determine the correct setting for this switch. If the end node is capable of only half-duplex, set the switch to HALF. If the end node is capable of full-duplex, set the switch to FULL.

The AT-FS705E FC switch has one 100FX DUPLEX switch for its one fiber optic port. The AT-FS706E FC switch has two switches for its two fiber optic ports.

9.Power ON the end nodes connected to the ports on the switch.

10.Check the LNK/ACTY LED for each port. The LED should be steady green or blinking. If a LNK/ACTY LED remains OFF, refer to “Verifying and Troubleshooting the Installation.” for assistance.

Verifying and Troubleshooting the Installation

This section contains information on how to verify the installation of the switch and how to troubleshoot the unit in the event a problem occurs.

Check the PWR LED on the front of the switch. If the LED is OFF, indicating that the unit is not receiving power, do the following:

Make sure that the power adapter is securely connected to a power source and that the DC power cord on the adapter is securely connected to the DC power connector on the switch.

Verify that the power outlet has power by connecting another device to it.

Try connecting the unit to another power source.

GTry using another power adapter.

22