Allstar Products Group AC9300 Control and Auxiliary Equipment, FLOOR, OUT of Reach of Children

D: CONTROL AND AUXILIARY EQUIPMENT

INSTALLATION OF A STANDARD WALL PUSH BUTTON OR DELUXE WALL STATION CONTROL

A standard wall push button is included		A CHILD OPERATING THE DOOR CONTROLS
in your hardware package, an optional
Deluxe Wall Station may be purchased		RISKS INJURY — OR DEATH — TO HIMSELF AND
from your installing dealer. The operat-		OTHERS. DO NOT ALLOW CHILDREN TO
ing parameters for the standard wall
push button and the Deluxe Wall Station		OPERATE ANY DOOR CONTROLS.
are outlined on pages that follow	WARNING	MOUNT THE PUSHBUTTON AT LEAST 5 FT FROM
(“Operating Instructions”) to see what
		THE FLOOR, OUT OF REACH OF CHILDREN.
mode of operation is right for you. All-
star recommends the Deluxe Wall Sta-

tion installation, as it will provide full

control over the garage door operator and its functions at all times. You may install one Deluxe Wall Station and one or more stan- dard push buttons to a Challenger AC9000 Series operator following the cautions and instructions outlined below.

STEP 1: After determining a suitable location, usually near the access door and at least 5 feet above the floor to prevent use by children, use the standard wall push button or Deluxe Wall Station as a guide to mark the mounting holes. Drill holes for drywall anchors or screws. NOTE: Do not mount directly to masonry walls. Use backer board.

STEP 2: A length of 2-conductor, #22 gauge wire (or heavier) is required to connect the control button to the garage door operator. Strip approximately 2” of the wire jacket from one end and 1/2” of insulation from each wire. Carefully connect one wire to each of the two terminals. Carefully tuck the loose wires into the case and mount the unit using appropriate screws.

STEP 3: Run the wire from the control button to the operator, supporting it at 18” intervals with suitable staples.	Leave a
sufficient length to make the necessary connections to the operator terminal strip.	104350

WARNING: SOME LOCAL BUILDING CODES DO NOT ALLOW		WARNING
SURFACE WIRING. BE SAFE AND CHECK WITH YOUR LOCAL	!
BUILDING INSPECTOR FIRST.

STEP 4: Ensure power is OFF to the operator or disconnect the power from the operator. Strip approximately 4” of jacket from the end of the wire and 1/2” insulation from each wire. Connect to terminals 0 and 1 as shown in the illustration. Support the wire near the operator with wire ties.

	Step	5: Install the
	Control			Button
	Warning			Label		Child can be pinned under automatic garage
109986	supplied		with		your
						door. Death or serious injury can result.
	Challenger			AC9000		•	Never let child walk or run under moving door.
	Series operator				near	•	Never let child use door opener controls.
	the	control		button		•	Always keep moving door in sight.
	(see	illustration).				•	If person is pinned, push control button or use
							emergency release.
	Repeat		the	Steps 1		•	Test door opener monthly:
	thru 5 above to in-						Refer to your owner’s manual
							Place one-inch object (or 2x4 laid flat) on floor.
	stall	additional			stan-		If door fails to reverse on contact, adjust opener.
	dard wall push but-						If opener still fails to reverse door, repair or replace opener.
	tons	if		desired.
	Every control				must	CONTROL BUTTON WARNING LABEL
	have a separate Con-
	trol	Button		Warning

Label mounted near it. Contact the factory for additional labels if needed.

WARNING

IMPROPER DOOR OPERATION COULD CAUSE INJURY OR DEATH. WARNING LABEL MUST BE MOUNTED ON WALL NEAR THE PUSHBUTTON. ALL WARNINGS AND INSTRUCTIONS ON THE LABEL SHOULD BE STRICTLY ADHERED TO.

12