The RTGR328N Sensor collects temperature and humidity readings, and signals from official
organizations for the
SET UP THERMO / HYGRO
SENSOR (RTGR328N)
1.Open the battery compartment with a small Phillips screwdriver.
2.Insert the batteries.
3.Set the channel and radio signal format. The switches are located in the battery compartment.
SWITCH | OPTION |
|
|
Channel | If you are using more than one |
| sensor, select a different channel |
| for each sensor |
|
|
Radio Signal | EU (DCF) / UK (MSF) |
Format |
|
|
|
4. Press RESET. Then set the temperature unit.
SWITCH | OPTION |
|
|
Temp | °C / °F |
|
|
5. Close the battery compartment.
BAR916HG_EN_OP.indd 11
To fold out the stand: | EN |
|
1
2
For best results:
•Insert the batteries and select the unit, channel, and radio signal format before you mount the sensor.
•Place the sensor out of direct sunlight and moisture.
•Do not place the sensor more than 70 metres (230 feet) from the main (indoor) unit.
•Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture.
•Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects.
•Position the sensor close to the main unit during cold winter months as
NOTE The transmission range may vary and is subject to the receiving range of the main unit.
You may need to experiment with various locations to get the best results.
11
5/8/06 11:23:21 AM
