Installation
Installing AV Interface Unit
This Unit can be placed inside the trunk, on the kick panel of the front passenger's seat or underdash. However, to avoid unnecessary signal wiring, it is better to mount the Unit as close as possible to the Display.
DO NOT MOUNT THE INTERFACE UNIT IN LOCATIONS EXPOSED TO MOISTURE OR EXTREME HEAT (such as the engine compartment).
Velcro fastener Mounting:
1.Place a Velcro fastener onto the mounting surface. The rough side should be facing the unit.
2.Remove the backing to the adhesive on the Velcro strips. Press the unit onto the mounting location.
Attaching with screws
1.Place the unit on the location chosen for installa- tion.
2.Mark the screw locations using the unit as a template.
3.Drill a hole less than 3 mm in diameter.
WARNING
When you are drilling a hole in the car body, be careful not to damage pipes, tanks or electrical wiring etc.. It might cause an acci- dent or a fire.
4.Firmly attach the unit using 4 of the supplied self- tapping screws (M4 x 14).
�
Velcro fastener (included)
