Basic Operation
Switching the Source
Main power lamp
1 Touch the option part of the display to display each source operation screen or source selection screen.
2 If each source operation screen is displayed, touch CONTROL on the upper right side of the screen to display the source selection screen.
• The source selection screen is displayed by touching |
“CONTROL” as described below, depending on the |
current source. |
(VOLUME DOWN) (VOLUME UP)
POWER
When touched while the current source is GAME, |
Illumination sensor
Screen Display ON/OFF
1 Press the POWER button.
2 To turn off the POWER, press the POWER button again.
•If properly connected, the monitors main POWER will turn off when the vehicle's ignition switch is off. If the main power lamp illuminates in the STAND BY mode, the vehicle's battery may be discharged.
•After turning the system off, a slight ghost of the image will remain temporarily. This is an effect peculiar to LCD technology and is normal.
•Under cold temperature conditions, the screen may lose contrast temporarily. After a short
Adjusting the Volume
1 Adjust the volume level by pressing the 
or 
button.
AUX 1 or AUX 2 : Source selection screen |
When touched while the current source is EXT.DVD: |
EXT.DVD operation screen → Source selection |
screen |
When touched while the current source is TV: TV |
operation screen → Source selection screen |
When touched while the current source is LINK: |
AUDIO operation screen → EXT.DVD operation |
screen → TV operation screen → Source selection |
screen |
3 Touch the source (NAV. / AUX 1/ AUX 2) you want to view.
SOURCE CONTROL
NAV. |
| AUX 1 |
| AUX 2 |
| SETUP |
| VISUAL |
| SOURCE |
| P 1/2 |
|
|
|
| EQ |
|
|
•The AUX 1, AUX 2 source name changes to the selected mode name in the next item “Setup Operation” - “6External input name setting”. Also, “NAV.” is only displayed when “7 Navigation Settings” in following section, “Setup Operation”, is set to “ON”.
•The operation screens for the different sources as well as the source selection screen turn off automatically if no operation is performed for 5 seconds.
