Information
In Case of Difficulty
If you encounter a problem, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer.
No function or display.
•Car's ignition is off.
-Turn the ignition on.
•No fuse or blown fuse.
-Check the cause and replace the fuse.
•Incorrect connections.
-Check connection and remedy.
•Vehicle's battery is weak.
-Check the voltage of vehicle's battery.
Unclear picture display.
•Fluorescent tube is exhausted.
-Replace the fluorescent tube*.
No picture display.
•Brightness control is set for minimum brightness control.
-Adjust the brightness.
•Incorrect setting of the VCR mode.
-Switch to the correct mode.
•Protective circuit is on because of high temperature.
-Wait until the temperature inside the vehicle comes down to the operating temperature range (45°C).
•Incorrect or open connection with the Monitor, AV interface unit.
-Check the connection and remedy.
Picture color is poor.
•Brightness/Color/Tint control are not set to the proper positions.
-Check each control.
Spots or dotted lines/stripes appear.
•Caused by neon signs,
-Change the location of your vehicle.
Unit does not operate.
•Monitor's power is not turned on.
-Turn on the monitor's power.
Navigation screen is not displayed or navigation system’s remote controller keys do not work.
•Navigation system’s power is turned off.
-Press the ON/OFF (POWER) button on the navigation system’s remote controller to turn the navigation system’s power on.
*The fluorescent tube replacement is not free of charge even within the warranty period, for the tube is an article of consumption.
