Alpine 68-00493Z15-B Foot brake lead Yellow/Black, 45Remote control output lead White/Brown

1Foot brake lead (Yellow/Black)

Connect this lead to the foot brake lead powered when the foot brake is pressed.

2Hand brake lead (Yellow/Blue) Connect this lead to the hand brake lead powered when the hand brake is pulled.

3Monitor control lead (White/Pink) Connect when upgrading with touch panel compatible products such as the IVA-D300.

45Remote control output lead (White/Brown)

To remote control input lead of ALPINE products used in the system.

6Reverse Lead (Orange/White)

Use only when a back-up camera is connected. Connect to the plus side of the car’s reverse lamp that lights when the transmission is shifted into reverse (R).

Switches the video picture to the back-up camera. This is linked with putting the car into reverse (R).

7ACC power lead (Red)

To ACC power lead powered when engine key position is ACC.

8Fuse (7.5A)

9Ground lead (Black)

Connect the lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.

pFoot brake lamp

qBrake connector (Included)

wFoot brake lead

eFoot brake switch

rHand (parking) brake lamp

tHand (parking) brake lead

yHand (parking) brake switch

uHeadphone

iMain monitor

oConnection cable ; RGB cable

aTo RGB output terminal

sMade by Alpine navigation

dAudio input connectors (AUX 1)

Use these connectors to input the audio signals from a DVD player, video deck etc.

fVideo input connector (AUX 1)

Use this connector to input the video signals from a DVD player, video deck etc.

gAudio input connectors (AUX 2)

Use these connectors to input the audio signals from a DVD player, video deck etc.

hVideo input connectors (AUX 2)

Use this connector to input the video signals from a DVD player, video deck etc.

jAudio output connectors

Use these connectors to output audio signals to a rear monitor, etc.

kVideo output connector

Use this connector to output video signals to a rear monitor, etc.

•When connecting to an IVA-D300 or VPE-S431, use the “AUX IN 1” connector. When connecting a rear view camera, use the “AUX IN 2”.

To prevent external noise from entering the audio system.

•Locate the unit and route the leads at least 10cm away from the car harness.

•Keep the battery power leads as far away from other leads as possible.

•Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis.

•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information.

•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

19-EN