Installation
Metal plate
Detachable
Front panel
Caution
When you install this unit in your car, do not remove the Detachable Front Panel.
If the Detachable Front Panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.
1 | Mounting Sleeve |
| |
| (Included) |
| Dashboard |
Slide the mounting sleeve into the dashboard.
2 | Screw |
Hex Nut (M5)
∗∗
Bolt Stud
Metal |
|
Mounting |
|
Strap | ∗ |
Ground Lead
Chassis
Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.
NOTE
For the screw marked **, use an appropriate screw for the chosen mounting location.
Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the
3
Lock Pin
Slide the
Removal
1Remove the DETACHABLE FRONT PANEL.
2Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not
3Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Face Plate
Screws (M5 ⋅ 8)
(Included)
Ground Lead
∗
Mounting Bracket
NOTE
Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.