• Crossover mode is automatically canceled if no buttons are pressed within 15 seconds.
• To cancel Crossover mode for all music source, press the MODE button to turn Crossover off.
9-EN
When setting to “F/R/Sub.W ”:
The unit can be operated 1n 2 way system.
3WAY F/R Sub. W
3 Press the g DN button or the f UP button to select desired cut-off frequency point(cross over point).
Adjustable frequency bands:
LOW : 20Hz to 200Hz(in 1/3 octave steps)
MID-L: 20Hz to 200Hz(in 1/3 octave steps)
MID-H: 20Hz to 20KHz(in 1/3 octave steps)
HIGH : 1KHz to 20KHz(in 1/3 octave steps)
4 Press the SOURCE button to select desired slope. Adjustable slope: FLAT(OFF)∗ ,6, 12, 18 or 24 dB/oct. ∗ FLAT cannot be set for the HIGH slope.
5 Turn the Rotary encoder to select the desired output level.
Adjustable output level: -12 to 0 dB.
To store the adjusted contents
1) Press and hold any one of the Preset buttons (1 through 6) for at least 2 seconds into which you wish to store the adjusted curve.
6 For setting another channel, repeat the steps 2 to 5.
7 After setting, press the T.CORR button to return to the normal mode.
NOTES
• About the 2way/3way system
You can switch to 2way/3way system mode with the 2way/ 3way switch on the side of the unit.(See on page 47)
When setting to “3 WAY ”:
The unit can be operated 1n 3 way system.
Adjusting and Storing the Crossover
Before performing the following procedures, refer to “About the Crossover ”(Page 8)
1 Press and hold the T.CORR button for at least 3 seconds.
< 2 WAY System >
2 Press the BAND button to select desired parameter.
<CDA-7998 >
→SUB.W → REAR → FRONT
<CDA-7897 >
→LOW(Subwoofer) → FRONT-HI → REAR-HI
3 Press the g DN button or the f UP button to select desired cut-off frequency point(cross over point).
Adjustable frequency bands: 20Hz to 200Hz(in 1/3 octave steps)
4 Press the SOURCE button to select desired slope. Adjustable slope: FLAT(OFF),6, 12, 18 or 24 dB/oct.
5 Turn the Rotary encoder to select the desired output level.
Adjustable output level: -12 to 0 dB.
To store the adjusted contents
1)Press and hold any one of the Preset buttons (1 through 6) for at least 2 seconds into which you wish to store the adjusted curve.
6 For setting another channel, repeat the steps 2 to 5.
7 After setting, press the T.CORR button to return to the normal mode.
NOTES
•Crossover mode is automatically canceled if no buttons are pressed within 15 seconds.
•To cancel Crossover mode for all music source, press the MODE button to turn Crossover off.
< 3 WAY System >
2 Press the BAND button to select desired parameter.
→ LOW → MID-L → MID-H → HIGH