Alpine CDA-9815, CDA-9813 Controls on Remote Control, Operating the Audio Processor, 30-EN

Remote Control

1

25

6 7 8

9

3!

4"

#

Controls on Remote Control

1Power Button

Press this button to turn the power on/off.

2Source Button

Press this button to select the audio source.

3-/JButton

Press this button to switch between the Play and Pause modes for CD.

4TILT 98 Buttons

Press this button to adjust the angle of the movable display.

5Band/Program Button Radio mode: BAND Button

Press this button and the band will change. CD/Changer mode: To switch the disc mode.

6Volume Adjustment Buttons To increase the volume level: Press the L button

To decrease the volume level: Press the K button

78 Button

Radio mode: Pressing this button will select, in ascending order, stations programmed into the radio's presets as shown below.

1 → 2 ... 6 → 1

CD Changer mode: DISC Select (UP) button

Press this button to select a disc in ascending order.

MP3/WMA mode: Press the Folder Select (UP) button to select the folder.

8g DN Button

Radio mode: SEEK (DN) Button

CD mode: Press this button to go back to the beginning of the current track.

9f UP Button

Radio mode: SEEK (UP) button

CD mode: Press this button to advance to the beginning of the next track.

!9 Button

Radio mode: Pressing this button will select, in descending order, stations programmed into the radio's presets as shown below.

6 → 5 ... 1 → 6

CD Changer mode: DISC Select (DN) button

Press this button to select a disc in descending order. MP3/WMA mode: Press the Folder Select (DN) button to select the folder.

"Mute Button

Press this button to lower the volume by 20 dB instantly. Press this button again to cancel.

#Audio Processor Button*1

CDA-9815/CDA-9813 only

Each press the button to switch the audio processor mode.

For details, refer to "Operating the Audio Processor" as shown below.

CDA-9815/CDA-9813/CDA-9811

Press the button to call the external audio processor mode when the external audio processor is connected.*2

*1 This button is used for CDA-9811 in conjunction with an optional Ai-NET processor.

*2 For the operation of external audio processor, refer to the Owner's Manual of the external audio processor you purchased.

Operating the Audio Processor

1 Press A.PROC to select the mode.

Normal mode → EQ mode (Equalizer Presets) → Private mode (Recalling the Stored Equalizer Curve) → Time Correction mode (Recalling the Stored Time Correction) → Crossover mode (Recalling the Stored Crossover) → Normal mode

2 Press 8 or 9 to select the mode.

EQ mode

Select from FLAT, POPS, ROCK and NEWS.

Private mode/Time Correction mode/Crossover mode Select from MEMORY 1 through 6.

30-EN