Getting Started
3 Grasp the front panel firmly, slide to the left | , | |
and then pull | to remove. |
|
/ 
/ENT Rotary encoder
(OPEN)SOURCE/
| /RTN | FUNC./SETUP |
Accessory List | ||
• | Head unit | 1 |
• | Power cable | 1 |
• | Mounting sleeve | 1 |
• | Carrying case | 1 |
• | Bracket key | 2 |
• Screw (M5 x 8) | 4 | |
• | Owner’s Manual | 1 set |
Turning Power On and Off
Press SOURCE/
to turn on the unit.
•The unit can be turned on by pressing any other button except
(OPEN) and TITLE.
Press and hold SOURCE/
for at least 2 seconds to turn off the unit.
•The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Detaching
1 Turn off the unit power.
2 Press 
(OPEN) to open the front panel.
To close the front panel, press the left side until it locks as shown in the figure below.
•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel). This is not a malfunction.
•To protect the front panel, place it in the supplied carrying case.
•When detaching the front panel, do not apply excessive force as it may result in malfunction.
•Do not leave the front panel open, or drive the car with the panel open as it may result in an accident or malfunction.
Attaching
1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
•Attach the front panel carefully, holding the sides of the front panel to avoid pushing buttons by mistake.
