1 | ISO Antenna Convertor Plug | " Remote Control Interface Connector | |
2 | Antenna Receptacle | To remote control interface box. | |
| Connect to the supplied ISO antenna convertor plug. | # DIN Connector | |
3 | Audio Interrupt In Lead (Pink/Black) | Connect this to the DIN connector on the CD changer. | |
| Connect this lead to the Audio Interface output of a cellular | $ Power Supply Connector | |
| phone which provides ground shorting when a call is | % Left Rear (+) Speaker Output Lead (Green) | |
| received. | & Left Rear | |
| If a device having the interrupt feature is connected, audio | ( Left Front (+) Speaker Output Lead (White) | |
| will be automatically muted whenever the interrupt signal is | ) Left Front | |
| received from the device. | ~ Right Front | |
4 | Remote | + Right Front (+) Speaker Output Lead (Grey) | |
| Connect this lead to the remote | , Right Rear | |
| amplifier or signal processor. | - Right Rear (+) Speaker Output Lead (Violet) | |
5 | Switched Power Lead (Ignition) (Red) | . ISO Connector (Speaker Output) | |
| Connect this lead to an open terminal on the vehicle’s fuse | / DIN Extension Cable (Included with CD changer) | |
| box or another unused power source which provides (+) 12V | NOTE | |
| only when the ignition is turned on or in the accessory | ||
| Older Alpine CD changer came with standard, straight type DIN | ||
| position. | ||
| connectors. In installations where an | ||
6 | Power Antenna Lead (Blue) | ||
simplify installation, the Alpine 491002 Adaptor can be used | |||
| Connect this lead to the +B terminal of your power antenna, | (sold separately). | |
| if applicable. | : Subwoofer Output RCA Connectors | |
| NOTE | RED is right and WHITE is left. | |
| ; Rear Output RCA Connectors | ||
| This lead should be used only for controlling the vehicle's power | ||
| RED is right and WHITE is left. | ||
| antenna. Do not use this lead to turn on an amplifier or a signal | ||
| processor, etc. | < Front Output RCA Connectors | |
7 | Ground Lead (Black) | RED is right and WHITE is left. | |
| Connect this lead to a good chassis ground on the vehicle. | = RCA Extension Cable (sold separately) | |
| Make sure the connection is made to bare metal and is |
| |
| securely fastened using the sheet metal screw provided. |
|
8Fuse Holder (15A)
9Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
!ISO Power Supply Connector
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
