Installing the Tuner Box
Caution
Do not block the unit’s fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.
Air ventilation hole
<Side of the tuner box>
When mounting with Velcro fasteners
When mounting the tuner with the Velcro fasteners, be sure to choose a flat location.
Do not hang the unit from the bottom of the dashboard or rear deck with the Velcro fasteners.
1 Remove the Protective paper and attach two pieces of Velcro fastener to the bottom of the Tuner.
Tuner Box
Protective paper
| Velcro Fasteners |
Protective paper | (Included) |
2 Check the position, and then fix the Tuner to the floor carpet.
When mounting with Screws
When mounting the tuner with the screws, be sure to choose a flat location.
When making holes, be careful not to scratch any pipes or wires.
1 Connect the bracket to both the flanks of the tuner with the supplied pan screws (M4 x 8).
Tuner Box
Bracket (Included)
Pan screws (M4 x 8) (Included)
2 Install the tuner on the floor with the supplied
Tuner Box
Installing the DC/DC Converter
Install the DC/DC Converter on the floor with the supplied
DC/DC Converter
Mounting the remote control holder
•If the remote control is in direct sunlight, remove it from the holder and keep it in the glove box.
•When the holder cannot be mounted securely with Velcro tape, mount it by using screws.
Reinforcement Screws
Remote Control
Remote Control
Holder
Protective paper
Console Box etc.