Before Setting MultEQ
WARNING
While driving, do not set up MultEQ.
To prevent accidents, do not set up MultEQ while driving. The setting of the MultEQ function is required to mount the microphone in the vehicle in order to measure sound characteristics. Also, during measurement, loud measurement tone (signal) from the speakers may be output. Making such settings may distract you from driving and result in an accident.
Read following provisions before setting MultEQ.
•The MultEQ setting should be made in as quiet a place as possible after turning off the engine, air- conditioner and heater. If you have a car phone or cellular phone in the vehicle, remove them from the vehicle or turn its power off. If sound other than measurement tone to be measured (engine or receiving sound of car phone, etc.) occur, sound measurement in the vehicle may not be accurate.
•When setting MultEQ, be sure to use the microphone supplied with this unit. If a microphone other than the supplied one is used, measurement may not be possible or sound measurement in the vehicle may not be accurate.
•If a power amplifier or a powered subwoofer with an input level control is connected and this level is lowered, measurement may not be possible. However, the input level should set lowered than normal level to adequately perform measurement.
•If a power amplifier with a
•If MultEQ is set and the function is turned on, MX,
•After you have stored the result of MultEQ you adjusted in the
Setting MultEQ
1 Prepare for MultEQ setting.
•Park the vehicle in a quiet location.
•Close doors, windows, sunroof, etc.
•Turn off the engine of the vehicle.
•Set the
2 Set the key position of the vehicle to ACC or turn it on.
•If an