34-EN
Installation and Connections
3Mount the spacer and bracket to the control unit.
Next, securely mount the factory brackets
removed from the factory radio, to the control
unit assembly.
Flush Mounting the control unit
1Make a cut-out approximately 178 (width) by 50
(height) mm (7 inches by 2 inches) in size at
your desired mounting location.
WARNING
When making cut-outs, be careful not to
damage pipes, tanks, electric wires, etc. Doing
so could lead to accidents or fire.
2After step 2 on “Mounting other units” of
“Mounting the control unit” page 33, remove the
side bracket.
3Remove the spacer from the bracket.
Side bracket
Side bracket
Spacer Bracket
4Mount the spacer on the control unit using the
included screws.
5Attach the flush mount brackets to the control
unit using the included screws. Mount this
assembly into the prepared cut-out.
Flush mount
Face plate
Self-tapping screw
(M2.6 x 8) x 4
Flat head screws (M5 x 8)
Bracket
Control unit
Spacer
Pan head screw
(M3 x 5) x 2