Alpine PXA-H701 X-OVER adjustment, F r o n t 2 1/2, H P f c, L P f c, 16-EN, Settings/Adjustments

L e v e l :

– 4 d B

9 Repeat steps 4 to 8 to adjust other channels.

10 Once the adjustments are completed, press the X-OVERbutton.

Check that the defeat mode is off. (See page 28.)

Settings/Adjustments

X-OVER

CHANNEL

ENTER

*1 When center is set to subwoofer, it is not displayed.

*2 When center is set to subwoofer, it becomes Sub.W(L).

*3 When center is set to subwoofer, it becomes Sub.W(R).

5 Turn the Rotary encoder to adjust the H.P.F. cutoff frequency, then press the ENTER button. The adjustable bands differ according to the channel (speaker).

Rotary encoder

X-OVER adjustment

This section describes the procedure for making the X-OVER adjustment. Before performing this procedure, see “X-OVER” on page 15.

The SLOPE to FLAT operation from the head unit may not be performed depending on the head unit combination.

1

2 Press the X-OVERbutton to set the X-OVER adjustment mode.

3 Press and hold the CHANNEL button for at least 2 seconds and select “L and R (LR)” or “L or R”.

L and R (LR) L or R

(factory default)

L and R (LR): Sets the same adjustment values for the left and right channels.

L or R: Different adjustment values can be set for the left and right channels.

4 Press the CHANNEL button to select the desired channel, then press the ENTER button.

When “L and R (LR)” is selected:

*1

Front 1 Front 2 Rear Center

Sub. W

When “L or R” is selected:

Front 1 L	Front 1 R	Front 2	L	Front 2 R
*3	*2
Sub. W	Center	Rear R		Rear L

X – O V EP R		F r o n t 2 1/2
H P f c :
	3	5 0
H P s l o	p e : 1		2
L P f c : 1		. 8 k
L P s I o p e : 6

6 Turn the Rotary encoder to adjust the H.P.F. slope, then press the ENTER button.

To set filter off (slope off), press and hold the X- OVER button for at least 2 seconds.

X – O V EP R	F r o n t 2 1/2
H P f c : 3	5 0
H P s l o p e :		1	8
L P f c : 1	. 8	k
L P s I o p e : 6

7 Next, make the adjust for the L.P.F. in the same way as in steps 5 and 6.

8 Turn the Rotary encoder to adjust the level, then press the CHANNEL button.

Press the ENTER button to return to step 5.

The level can be adjusted between –12 and 0.

X – O V PE R F r o n t 2 2/2

16-EN