Alpine PXA-H701 owner manual 34-EN, Installation and Connections, Flush Mounting the control unit

Installation and Connections

3 Mount the spacer and bracket to the control unit. Next, securely mount the factory brackets removed from the factory radio, to the control unit assembly.

Flat head screws (M5 x 8)

4 Mount the spacer on the control unit using the included screws.

Spacer

Control unit

Pan head screw (M3 x 5) x 2

5 Attach the flush mount brackets to the control unit using the included screws. Mount this assembly into the prepared cut-out.

Bracket

Flush Mounting the control unit

1 Make a cut-out approximately 178 (width) by 50 (height) mm (7 inches by 2 inches) in size at your desired mounting location.

WARNING

When making cut-outs, be careful not to damage pipes, tanks, electric wires, etc. Doing so could lead to accidents or fire.

2 After step 2 on “Mounting other units” of “Mounting the control unit” page 33, remove the side bracket.

Flush mount

Self-tapping screw (M2.6 x 8) x 4

Face plate

Side bracket

Side bracket

3 Remove the spacer from the bracket.

Spacer

Bracket

34-EN